Splendid presentation about magnetic separator

Working principle:

After the ore slurry tank into the tank after the water pipe water to the mine under the influence of mineral particles showed a loose state to enter the tank of mine. In the magnetic field, magnetic mineral particles occur together and form a “magnetic group” or “flux”, “magnetic group” or “flux” in the pulp by the magnetic effect, movement to the pole, and were adsorbed on the cylinder. As the magnetic polarity along the cylinder rotation is alternately arranged, and fixed and at work, 'magnetic group' or 'flux' in the rotation with the cylinder, due to alternating magnetic poles arising from the phenomenon of magnetic stirring, is mixed in the 'magnetic group' or 'flux' in the non-magnetic gangue minerals such as falling down and turning in, eventually being sucked in the cylinder surface 'magnetic group' or 'magnetic lotus' is the concentrate .Concentrate the magnetic lines to the edge of the cylinder with the weakest at the magnetic field in the discharge of mine water spray rinse under water to the concentrate tank to be unloaded, if the whole magnetic roller, brush roller unloading ore is conducted . Non-magnetic or weakly magnetic minerals are left with the pulp in the pulp discharged outside the tank , that is tailings.

Basic structure:

Wet magnetic separator: Mainly by the cylinder, roller, brush roller, magnetic system, tank, transmission parts 6 parts. Cylinder by the volume 2-3mm stainless steel welded tube, end caps for the aluminum pieces or parts, screws and stainless steel tube connected. Or directly by the motor reducer motor with steeples speed, drive cylinder, magnetic roller and brush roller for rotary movement. Magnets with stainless steel bolts installed in the yoke of the floor, out of the yoke of the tube axis, the shaft fixed with knee arm. Pulling the magnetic system can be adjusted knee arm angle adjustment lever can be fixed after appropriate.